Ryobi LRS-180 Manuel D'utilisation page 5

GB
FR DE ES
OPERATION
Depress the lock-off button, then pull switch trigger to
start the cutting action. Place the base assembly against
the work, then move the blade into the work. Do not
force. Use only enough pressure to keep the saw cutting.
Let the blade and saw do the work. Use of excessive
pressure that causes bending or twisting of the blade
may result in broken blades.
PLUNGE CUTTING (Fig. 5)
Mark the line of cut clearly. Choose a convenient starting
point inside the area to be cut out and place the tip of the
blade over that point. Rest front edge of base assembly
on work and hold firmly in position. Depress the lock-off
button, then pull switch trigger to start the cutting action.
WARNING
Make sure blade does not touch work until motor
reaches full speed, since this could cause loss of
control resulting in serious injury.
With saw blade at full cutting speed, slowly tilt saw
downward until tip of blade starts cutting work.
After blade penetrates work, tilt saw until blade is
perpendicular to the work.
METAL CUTTING (Fig. 6)
Metals such as sheet steel, pipe, steel rods, aluminium,
brass, and copper may be cut with your saw. Be careful
not to twist or bend the saw blade. Do not force.
We recommend cutting oil when cutting most soft metals
and steel. Cutting oil will also keep blades cool, increase
cutting action, and prolong blade life.
Never use petrol since normal sparking of motor could
ignite fumes. Clamp the work fi rmly and cut close to
the clamping point to eliminate any vibration of the work
being cut. When cutting conduit pipe or angle iron,
clamp work in a vise if possible and cut close to the
vise. To cut thin sheet material, "sandwich" the material
between hardboard or plywood and clamp the layers to
eliminate vibration and material tearing.
MAINTENANCE
WARNING
When servicing, use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
IT NL PT DK SE FI NO RU PL CZ
English
WARNING
Do not at any time let brake fl uids, gasoline,
petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modifi cation is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
ENVIRONMENTAL PROTECTION
SYMBOL
V
-1
min
2
HU RO LV LT EE
Recycle raw materials instead of disposing as
waste. The machine, accessories and
p a c k a g i n g s h o u l d
environmental-friendly recycling.
Safety Alert
Volts
Revolutions or reciprocations per minute
Direct current
CE Conformity
Please read the instructions carefully before
starting the machine.
Recycle unwanted
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
HR SI SK GR TR
b e s o r t e d f o r