Ryobi LRS-180 Manuel D'utilisation page 4

GB
FR DE ES
SPECIAL RULES
PROTECT YOUR LUNGS. Wear a dust mask if
Q
operation is dusty.
PRODUCT SPECIFICATIONS
Motor
Blade Stroke
Maximum Cutting Thickness
(wood)
No Load Speed
Switch
MODEL BATTERY PACK
(not included)
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
BPL-1820
LRS-180 BPL-1815
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
FEATURES
1. Lock-off button
2. Depress here to pull switch trigger
3. Switch trigger
4. Blade clamp lock / release lever
5. Saw blade
6. Battery pack (not included)
7. Latches
8. Depress latches to release battery pack
9. Blade clamp
10. To install/to release
11. To lock
12. Blade shown correct in saw bar
OPERATION
WARNING
Always remove battery pack from your saw when
you are assembling parts, making adjustments,
assembling or removing blades, cleaning,
or when not in use. Removing battery pack will
prevent accidental starting that could cause
serious personal injury.
IT NL PT DK SE
18 V
22 mm
60 mm
0-3000 min- 1
Variable Speed
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
BC-1815S
BC-1800
FI NO RU PL CZ
English
TO REMOVE / ATTACH BATTERY PACK
(NOT INCLUDED) (Fig. 2)
TO REMOVE
Locate latches on side of battery pack and depress
Q
both sides to release battery pack from your saw.
Remove battery pack from your saw.
Q
TO ATTACH
Place the battery pack in your saw aligning raised
Q
rib on battery pack with groove in saw's battery port
(Fig. 2).
Make sure the latches on each side of the battery
Q
pack snap into place and battery pack is secured to
saw before beginning operation.
BATTERY PROTECTION FEATURES
RYOBI 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these built-in
features may cause the battery and the tool it is powering
to act differ-ently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running. To reset the battery and tool, release the trigger
and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack
will begin charging when placed on the lithium-ion charger.
TO INSTALL SAW BLADE (Fig. 3)
Remove battery pack (Fig. 2).
Q
WARNING
Failure to remove battery pack from saw could
result in accidental starting causing possible
serious personal injury.
Lift blade clamp lock/release lever on side of saw.
Q
Insert saw blade between blade clamp and saw bar.
Q
Lock blade clamp lever.
Q
Replace battery pack.
Q
GENERAL CUTTING (Fig. 4)
Hold your saw firmly in front of and clearly away from you.
Make sure saw blade is clear of any foreign material.
Be sure material to be cut is held firmly. Small work pieces
should be securely clamped in a vise or with clamps to the
work bench or table. Mark the line of cut clearly.
1
HU RO LV LT EE
OPERATION
HR SI SK GR TR