Pro Work PHS1200 Mode D'emploi page 6

Anleitung PHS 1200 SPK 1
GB
1. Description
1. Handle
2. Nameplate
3. On/Off switch
4. Interlock button for On/Off switch
5. Lock screw for the depth of cut setting
6. Power cable
7. Splitter
8. Hinged guard hood
9. Screw
10. Shoe
11. Flange
12. Saw blade
13. Parallel stop
14. Lock screw for the parallel stop
15. Lock screws for mitre cuts
16. Dust extractor connection
17. Additional handle
18. Actuator for the hinged guard hood
Please read these instructions carefully and pay
particular attention to the safety regulations. Keep
the instructions together with the circular saw.
2. Technical data
Voltage 230 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 160 mm dia.
Saw blade mount 20 mm dia.
Saw blade thickness
Sound pressure level LPA 96 dB(A)
Sound power level LWA 107 dB(A)
Vibration a < 2,5 m/s
W
Weight
Totally insulated
3. Applications
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
6
30.08.2004 10:21 Uhr
4. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
5. Working with the hand-held
circular saw
Always hold the circular saw firmly.
The hinged guard hood will be pushed back
automatically by the workpiece.
Never apply force! Advance the circular saw gently
and steadily.
The off-cut piece should be to the right of the
circular saw so that the wide part of the base plate
is supported over its entire surface.
When sawing along a marked line, guide the
circular saw along the corresponding groove.
Clamp small pieces of wood securely before
sawing. Never hold them in your hand.
Always observe the safety regulations! Wear
goggles!
Do not use defective saw blades or blades with
cracks or flaws.
Do not use flanges or flange nuts with a hole
which is larger or smaller than that of the saw
blade used.
1200 W
Do not try to stop the saw blade with your hand or
by applying pressure to the side of the blade.
4500 rpm
The hinged guard must not jam and must return to
55 mm
its original position once work is completed.
Before plugging in the circular saw, check that the
38 mm
hinged guard is functioning properly.
Before each use, always check that the safety
devices - the hinged guard, splitter, flanges and
adjustment devices - are functioning properly and
2,4 mm
have been adjusted and secured correctly.
You can connect a suitable dust extractor to the
guard hood. Check that the dust extractor is fitted
securely and properly.
The hinged guard hood is not to be wedged in the
2
retracted guard hood when sawing.
3,6 kg
II/®
Seite 6