Cleaning And Maintenance - Princess 4 Men Wet'n Dry Mode D'emploi

Step 2. Back of the head
Use comb attachment 1 or 2 to cut the back of the head.
Step 3. Side of the head.
Use the shorter settings of comb attachment 1 for cutting the sideboards - the hair directly in front of the
ears. After that, change the comb attachment to a longer length and continue cutting to the top of the head.
Step 4 Top of the head.
Use comb attachment 1 or 2 to cut the hair on the top of the head from back to front against the direction
of growth of the hair. In some cases you may have to work from front to back. The comb attachment 1 is
to make short, cropped hair. If you want to keep the hair on top of the head longer, you must use a comb
to keep the hair above the head. Cut with the clippers above the comb, or hold the hair between the fin-
gers and cut it off at the desired length. Always work from the back of the head. Gradually cut the hair
shorter by reducing the distance between the comb, or the fingers, and the head. Use the comb regularly
to check whether there are any uneven locks and to comb out cut-off hair.
Step 5 The finishing touch.
Finally, for a good, accurately finished cut, remove the comb again and turn the clippers over (with the
bottom side up), so that you can touch up the bottom of the neck area, the sides and the area around the
ears. Put the adjustable cutting length button onto the lowest setting. Hold the clippers at a right angle to
the head, with the points of the cutting blade lightly touching the skin, and work in a downward direction.
This will produce just as smooth a result as if you had used a razor-blade.
Cutting longer hair.
If you want the hair tapered, then first part and comb the hair as usual. Now divide the hair on the head
from behind into three equal parts around the head. Fix the two upper layers with pins, so that they will
not be in the way when you cut the lowest layer. After that, proceed to cutting with a pair of scissors or
with the help of the clippers in combination with the styling comb.

CLEANING AND MAINTENANCE

After each use remove hair clippings with the cleaning brush.
You can clean the outside of the clippers with a soft, damp cloth.
TIPS
- For safety reasons, this appliance may not be used within one meter of a bathtub or shower, nor above
a washbasin filled with water. Never hold it under water!
- Only allow children or those with a disability to use the appliance if supervised.
- Handle the cutting blades carefully; do not drop them or bump them against hard objects. Do not use
the clipper if the cutting blades are damaged!
- If the appliance is defective, have it repaired or serviced by our service department. Do not use the
appliance if it is damaged or if the lead is damaged; send it to our service department.
BATTERIES
This appliance contains a rechargeable battery. It can be removed by loosening the screw on the back.
Now the battery can be cut loose and removed.
Batteries are chemical waste; do not simply throw them away. If the batteries are empty,
put them in the environmental box or bring them into your sanitation service and follow
further instructions from the municipality.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
BROWN
NEUTRAL
LIVE
7