Safety Recommendations - FONESTAR PAR-180L Mode D'emploi

EN
- It is possible to connect several devices in cascade to be managed collectively or separately. Connect an
XLR cable between DMX IN input of the device and the DMX OUT output of the DMX control console if it
is the first element in the chain, or the DMX OUT of the previous element in the chain of your show lighting
assembly.
- The total interconnection wiring of devices in a line must not exceed 100 meters. To avoid interference in
the line, it is advisable to place a line terminator consisting in a resistance of 120 Ω between the terminals
2 and 3 of the XLR DMX OUT connector of the last element. See diagram below:

SAFETY RECOMMENDATIONS

- Do not open the equipment under any circumstances.
- Make sure that the devices are at least 50 cm away from inflammable substances or elements.
- Do not look at the laser beams from a distance of less than 15 cm or for more than 10 seconds of direct
radiation, to avoid serious damage to eyes.
- Switch the equipment off for 15 minutes every 2 hours to avoid overheating.
- Do not continually switch the equipment on and off as this could decrease its useful life.
- Only use this equipment in covered and refrigerated spaces.
- Do not move or manipulate the equipment while it is connected to the mains and operating.
- Do not modify the lighting elements of the equipment without technical supervision or with material that
has not been guaranteed by the supplier.
- 4 -