Programming; Reset Ecc To Default Settings - effegibi NUVOLA SMART POWER Manuel D'utilisation Et D'entretien

EN NUVOLA SMART POWER OPERATING AND MAINTENANCE MANUAL
6.2

PROGRAMMING

The Effegibi Experience My Hammam app makes it possible to programme the Hammam to switch on at
a precise time on a particular day of the week.
At 3.00am on the programmed day, the control panel will switch on, the clock icon will light up and the
Hammam button will flash, indicating the programming (see fig. M).
fig.M
Hammam button flashing
The daily programming can be deactivated by switching off the control panel using the ON/OFF button.
The Hammam/Turkish bath can also be used when the programming icon is lit up, but if the daily
programming is still required, the control panel must not be switched off at the end of the session,
otherwise the programming will be cancelled.
If one daily program is deactivated, all the settings for that day will be cancelled.
If a new program has been set for the following day, the panel will switch on at 3.00am on that day.
N.B.: programs are controlled by the ECC - Effegibi Comfort Control function, which, if disabled, will
cancel them.
6.3 RESETTING THE EFFEGIBI COMFORT CONTROL FUNCTION TO THE FACTORY SET-
TINGS
If the Effegibi Comfort Control app doesn't work, the function can be reset by pressing the following
buttons in this order:
Press the temperature control buttons C and A in quick sequence and they will glow brighter, and hold
down the temperature control button C for about 3 seconds.
The button will flash twice and then twice again in quick succession to confirm the function has been
reset.
20
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes
Programming activated icon
without having to give prior warning or replace this manual.