Grizzly ERM 1600-34 L Mode D'emploi page 62

GB
• Use only spare parts and ac-
cessories supplied and recom-
mended by the manufacturer.
The use of non-original parts
will immediately invalidate the
guarantee.
• Prior to use, always check the
cord and extension cord for
signs of damage or wear. Im-
mediately disconnect the cord
from the mains in case it is
damaged in use. Do not touch
the cord until it is unplugged.
Do not operate the appliance if
the cord is worn or damaged.
Working with the Equipment:
Do not place feet or hands
near or under rotating parts
when working. Risk of injury!
Observe the noise protec-
tion and local regulations.
• Switch on the motor accord-
ing to the instructions and only
when your feet are at a safe
distance from the cutting tools.
• Do not use the equipment in
the rain, in poor weather, in a
damp environment, or on wet
grass. Work only in daylight or
with good lighting.
• Do not work with the equip-
ment when tired, lacking
concentration or under the
influence of alcohol or drugs.
Always take breaks in good
time. Take a sensible approach
to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
62
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment
carefully and in accordance
with the directions in these
instructions. Ensure sufficient
distance between feet and the
rotating blades.
• Do not tilt the unit when start-
ing it up, unless this is required
when starting up in long grass.
In this case, tilt the device
only slightly to the side using
the bow-type handle. Always
check that both hands are in
the working position before
returning the equipment to the
ground.
caution! Danger! The blade
continues to run after switch-
ing off.
There is a risk of injury.
• The equipment is not to be
lifted or transported while the
motor is running. Switch off
the equipment if it has to be
tilted in transit, when crossing
surfaces other than grass, and
when the equipment is being
transported to and from the
surfaces to be mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.