4....-05-CB 856
GB
•
Read the operating instructions carefully before putting the appliance into ope-
ration and keep the instructions including the warranty, the receipt and, if possi-
ble, the box with the internal packing.
•
The appliance is designed exclusively for private use and for the envisaged pur-
pose. This appliance is not fit for commercial use. Do not use it outdoors (except
if it is designed to be used outdoors). Keep it away from sources of heat, direct
sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the
appliance with wet hands. If the appliance is humid or wet, unplug it immediate-
ly. Do not put it in water.
•
When cleaning or putting it away, switch off the appliance and always pull out
the plug from the socket (pull on the plug, not the cable) if the appliance is not
being used and remove the attached accessories.
•
Never leave the appliance unsupervised. To protect children from the dangers
posed by electrical appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
•
Check the appliance and the cable for damage on a regular basis. Do not use
the appliance if it is damaged.
•
Do not try to repair the appliance on your own. Always contact an authorized
technician. To avoid the exposure to danger, always have a faulty cable be
replaced only by the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
•
Use only original spare parts.
•
Pay careful attention to the following "Special Safety Instructions".
Special safety instructions for this device
•
Keep the device away from water and moisture such as, for example, bath tubs,
shower areas or even persons taking a bath! Such situations constitute a DAN-
GER TO LIFE through electric shock! Attention: The nozzles become hot during
operation!
•
As additional protection we recommend the installation of a fault current protec-
tion device (RCD) with a rated current of not more than 30 mA in the wiring
system of the bathroom. Please contact an authorised electrician for advice..
1. Fully unwind the mains cable.
2. Ensure that the round brush is fixed firmly in place.
3. Insert the plug into a duly installed 230V/50Hz protective contact socket.
4. When your have dried your hair with a towel (no longer wringing wet), turn it
evenly around the round brush or shape your hair with the curler switched on as
desired.
18
15.03.2002 9:41 Uhr
General Safety Instructions
Initial and General Use
Seite 18