Main Controls - Denon Professional DN-408X Guide D'utilisation

11. Monitor Knob: Adjusts the pre-fader level of the signal sent from that channel to the
Monitor Mix, whose level is controlled by the Monitor Fader.
12. DFX Knob: Adjusts the post-fader level of the signal sent to the mixer's effects
processor, whose level is controlled by the DFX Return Fader (DFX Rtn).
13. Channel Pan / Balance: If this knob is labeled Pan, it adjusts the (mono) channel's
position in the stereo field. If the knob is labeled Bal, it adjusts the balance between the
left and right channels of that stereo signal.
14. Channel Mute: Press this button to mute/unmute the channel. The LED next to the
button will light up when the channel is muted.
15. Channel Fader: Adjusts the audio level on the channel.
16. Signal LED (Sig): Indicates that the channel's incoming audio signal is within an optimal
range.

Main Controls

17. Aux Send: Use 1/4" (6.35mm) TRS cables to
connect these outputs to the inputs of an external
amplifier or active monitor. Use the Monitor
Knob (Mon) on each channel to control the level
of the signal sent to Aux Send 1. This is useful for
creating a custom monitor mix for onstage
musicians.
18. Aux Return (Aux Rtn): Connect the outputs of an
external device to these inputs with 1/4" (6.35mm)
mono cables. If your source is mono, plug it into
the left jack and it will be heard on both the left
and right sides.
19. Aux Return Fader (Aux Rtn): Controls the audio
level sent into the Aux Return (Aux Rtn) inputs.
20. Graphic Equalizer: When the EQ On/Off switch
is on (depressed), you can use these controls to
adjust the equalization of the main mix.
21. EQ On/Off: Enables or disables the Graphic
Equalizer.
22. Main Out / Monitor Out: When this button is
raised, the Graphic Equalizer will affect the signal
sent to the Main Mix Outputs. When this button
is depressed, the Graphic Equalizer will affect the
signal sent to the Aux 1 (Mon) Output.
23. Effect Selector: This knob determines what
effect the mixer's internal effects processor will
apply to the various channels. Turn the knob to
change the effect number, and push the knob to
select it. The display next to the DFX Mute button
will show the preset number. Each channel can
send different levels of audio to the processor by
adjusting its DFX Knob. See the
for an explanation of the available effects.
23
33
34
14
Effects section
40
18 17
18 17
20
21 22
25
24
31 29
32 30
14 14
26 19
35
27
28
39
38
37
14
36
5