Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Features
Top Panel
Channels
Note: The channels have essentially the
same controls with some minor variations
between Channels 1–2, 3–4, 5/6, and
7/8. The four different channel types are
shown here.
1.
Mic Input: Connect a microphone or
line-level device to these inputs with
an XLR cable.
2.
Line
Input:
devices to these inputs with 1/4"
(6.35mm) cables.
3.
Insert:
Use
(6.35mm) TRS cable to connect an
external
processor
compressor, limiter, external EQ unit,
etc.) to this jack. The signal will be
taken after the channel's gain control
and returned before the channel's
EQ controls. The tip of the TRS
connection is the send, and the ring
is the return.
4.
Gain: Adjusts the channel audio level
(pre-fader and pre-EQ gain). Adjust
this so that the Signal LED lights up.
5.
Peak LED: The LED will flash if the
signal is clipping. If this happens,
decrease the setting of the Gain
knob.
6.
Low Cut Filter: When this button is
depressed, that channel's audio will
be sent through a 75 Hz low-
frequency filter with a slope of 18 dB
per
octave.
reducing low-frequency noise when
using microphones.
7.
Compressor: Adjusts the amount of
compression on the channel, applied
by the mixer's built-in compressor.
The LED next to the knob will light up
when the compressor is on.
8.
Hi EQ: Adjusts the high (treble) frequencies of the channel.
9.
Mid EQ: Adjusts the mid-range frequencies of the channel.
10. Low EQ: Adjusts the low (bass) frequencies of the channel.
4
Connect
line-level
a
standard
1/4"
(such
as
This
is
useful
for
1
1
2
2
3
3
5
4
4
6
7
a
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
1
2
2
3
3
5
5
4
4
6
6
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
16
5
16
Publicité
Table des Matières
