Power On - Sunstech TAD896QCBTK Mode D'emploi

User Manual
TAD896QCBTK
Make sure you use the original USB charger to charge your TAD896QCBTK or any
charger totally compatible (same connector, V and mA).
1. First connect the USB cable to the charger, and plug the charger into a wall outlet,
and then connect the micro-USB end of the cable to your TAD896QCBTK.
2. When the battery is full, disconnect the charger from the TAD896QCBTK, then
from the wall outlet.
You don't need to charge the battery for a specific length of time, and you can use
the TAD896QCBTK while it's charging.
If the battery is completely discharged, it may need to charge for up to 20 minutes
before you can use your TAD896QCBTK. The charging indicator may not be displayed
in this time.
First start up

Power On

Press and hold the POWER button during 5 sec approximately and the display will
power on and show the SUNSTECH logo.
6
English