Battery Charging - Play2Run AE20 Guide De L'utilisateur

► Rear connection description

► Battery charging

First use
It is important to fully charge your speaker before the first use.
To do this connect the USB power cable on the power DC IN plug.
You can use a computer USB port to charge your speaker or a mains charger with a USB plug
type PW2 - Play2Run
The LED on the front lights red during charging. When charging is complete it off.
The first full cycle can take up to 3 hours.
Charging guide
It is recommended to charge the battery when the indicator light flashes red and you
hear five beeps every 10 seconds..
If you have not used your speaker for several weeks it is possible that the LED does not
light up. In this case proceed to a full load as for initial use.
We recommend that you charge your speaker at least once every two months.
► Using Line in mode
Disabling Bluetooth
You can disable the Bluetooth
To do this, press 3 seconds on the multifunction button
The light on the front turns red and you hear a long beep.
To re-enable the Bluetooth
The light on the front flashes blue three times and you will hear a long beep
Using Line in mode
You can connect directly to the back of your speaker audio sources using 3.5mm audio jack
cord provided.
Connect your audio source to the Audio LINE IN input on the back
Adjust the volume level using your playback device.
The signal must be line level, like the level of a CD player or MP3 player.
After use, set the switch to OFF to save battery.
In this case the function settings will not act, only your external player control
Power
DC IN
®
.
®
®
in order to use only audio.
®
, press 3 seconds the multifunction button.
Audio
LINE IN
English