Publicité
Les langues disponibles
Les langues disponibles
Setting ( Main and Backup).
1. Blank Threshold Filter.
The value "Blanlk Threshold" sets the level when the signal is considered as missing. Threshold varies from -45 to
+15dBu, step 1 dB . When enabled this filter outputs an audio type alarm.
This filter computes RMS level instead of PEAK level.
2. Alarm Delay
This parameter sets the time from the error detection to the "ALARM" on CSS205.
Obviously if the error disappears during that time, the CSS205 will not got to "ALARM".
3. Reset Delay
These value set the time between error disappearance and CSS205 alarm cancellation, and return to the main source.
Should an other error occur during this time CSS205 stay on "ALARM "
4. Audio Mode
CSS205 runs 4 audio modes :
Left or right, watch over is on both channel. Should an error occur on Left or Right, CSS goes on ALARM
Left and Right watch over is on both channel. Should an error occur on both and only on both Left and Right, C S S
goes on ALARM.
Left, watch over only on left channel.
Right, watch over only on right channel.
Note:
RAMI
WEB INTERFACE - next -
Parameter
Check box
Blank Threshold
Enable/disable
Parameter
Value
Alarm delay
1 ~ 180
Parameter
Value
Reset delay
1 ~ 180
To save the configurations
Value
Comment
0 ~ -60
threshold in dBu
Comment
Delay (second)
Comment
Delay (second)
When an audio mode is on the key changes to blue.
Only an audio mode can be on in the same time.
27
RAMI - CSS205
Publicité
Chapitres
