Carat DPSK010000 Manuel D'instruction page 9

11. Loosen the screws
12. Take (d) the small part of the M-adapter off.
16. Mount the large part of the B- or H-adapter.
17. Tighten the flat HD screws with the wrench (do not
forget to mount the cup washers!).
18. Mount the small part of the B- or H-adapter.
5. MAKE IT FIT TO THE ANGLE GRINDER
13. Loosen the flat HD screws with the supplied wrench.
14. Take (d) the large part of the M-adapter off.
15. De-assemble the replacing B- or H-adapter
19. Tighten the 2 screws to assemble the small and large
part of the adapter (do not forget to mount the
spring washers!).
4. Hold 3 points of the connector and tighten the
screws firmly.
WARNING:
Make sure the collector is securely attached,
otherwise it could loosen and cause injuries.
9