Handle Assembly - Garlando Open Air Guide D'assemblage

Match the two half bearing retainers code 2AN201-24 by resting them on the bar while keeping them slanting so
that the protruding part "A" is in front of the hollow part "B", then bring them vertical by a slight pression.
Insert the outer half bearing retainers code 2AN201-2 onto the bar at the outer cabinet

Handle assembly

Warning: do not insert the handles if the plastic is cold. In this last case warm them before their insertion.
Insert manually the knob without covering the bar knurling. Slightly hammer until the knob hides the knurling.
Use the screws code 2A5-3.5X25E to fix the
bearing retainers. Use a cross screwdriver.
In case you prefer an electric screw driver, set
the torque at the minimum.
22