VT 400 Mode D'emploi page 14

!
The pump should always be placed as level as possible and not in the bottom
sludge. If necessary, you should use an elevation, made from a number of stones.
!
The pump should be used exclusively in the water (wet installation).
!
The temperature of the water to be displaced may be maximum 35 °C.
!
When the pump is completely installed, it can be connected to the power supply.
DESIGNS
Super Fountain Pumps are available in 6 designs, namely:
l Super Fountain 400 capacity on water level 480 l/h and delivery head 1,0 m
l Super Fountain 800 capacity on water level 800 l/h and delivery head 1,2 m
l Super Fountain 1000 capacity on water level 1050 l/h and delivery head 1,4 m
l Super Fountain 2000 capacity on water level 1950 l/h and delivery head 1,95 m
l Super Fountain 3000 capacity on water level 2900 l/h and delivery head 2,3 m
l Super Fountain 4000 capacity on water level 4000 l/h and delivery head 3,0 m
Parts and accessories (for explanation see the numbered illustration).
1. Preliminary filter scale with filter foam (stops coarse dirt particles)
2. Distribution valve for branching off to filter, brooklet or spraying ornament (20 mm
connection, continuous control)
3. Vertical adjusting mechanisme for tube
4. Fountain tube for nozzle (several parts)
5. Water bubble
6. Fountain
INSTRUCTIONS FOR USE
Fountain Pumps are supplied completely in a box. They are ready for use in a pond.
Assemble the pump parts as shown on the illustration. Mount the nozzle you want.
Place the fountain pump ca. 50 cm below water level. If necessary, use an elevation
of stones or a stand. Adjust the nozzle in such a way that it will protrude ca. 15 cm
above the water level. Place the fountain tube vertically compared to the water sur-
face with the help of the adjustable mechanisme. When the fountain pump has been
mounted completely, you can put in the plug. With the distribution valve supplied
along, a branching off can be made for a filter, a brooklet or a spraying ornament.
Attention
Inspect the flex and the electric connections prior to use for any damage. Take care
that the plug and the receptacle are dry. For safety reasons any repairs to the flex and
the pump motor may only be carried out by VT (see guarantee).
MAINTENANCE
The Super Fountain Pumps are equipped with motors which have a long life-time
and low energy use. The motors are entirely closed watertight and in principle they
are maintenance free. The built-in security device will switch the motor off in case
of overheating. Having cooled down for some time, the motor will start again.
Please remember that, as the occasion arises, the preliminary filter scale and impel-
ler should be cleaned before putting the pump into use again (see also below).