Technical Data - Profi Care PC-EZS 3056 Mode D'emploi

English
Cleaning
ATTENTION:
Never use harsh or abrasive detergents.
1. Turn the appliance off before cleaning it.
2. The appliance housing can be wiped down with
a slightly damp cloth.
3. Turn the brush attachment to the right and clean it
under running water after every use.
NOTE:
The components cannot be cleaned in the dishwasher.
Charging Station
WARNING:
Pull the plug out of the socket each time before you
clean the device.
NOTE:
The charging station is splash proof.
1. Regularly wipe the brush holder and lid first with a
damp cloth and then with a dry one.
2. Wipe the charging station's exterior first with a damp
cloth and then with a dry one.
3. Allow the brush holder and lid to dry completely
before closing the lid again.
4. Only put the plug back into the power outlet when
the charging station is completely dry.
Removing and replacing the decorative trim for
cleaning
1. Hold the bottom of the charging
station with one hand, with the
other hand push the panel together
as indicated by the arrows and pull
it off the bottom. You can now clean
the decorative trim.
2. To re-assemble the appliance place
the bulge on the underside of the
panel carefully onto the opening in
the charging station as shown. Then
press the panel into place.

Technical data

Model: .................................................................. PC-EZS 3056
Net weight: ...............................................................0.80 kg
Charging Station
Power supply: .................................. 100–240 V~; 50/60 Hz
Power consumption: .................................................. 1.4 W
Protective system: ........................................................ IPX7
Protection class: .................................................................II
Toothbrush
Rechargeable battery: . ...............260 mAh Li-Ion, DC 3.7 V
Protective system: ........................................................ IPX7
Protection class: ................................................................III
The right to make technical and design modifications in
the course of continuous product development remains
reserved.