Cleaning And Maintenance - PALSON Berlin Mode D'emploi

DIRECTIONS
- Unroll the power cord from its storage underneath the appliance. The appliance should be placed on a flat, firm surface.
- Before filling with water, make sure that the plug is unplugged from the mains.
- Fill the appliance with water at the desired temperature (max. 2 litres). The water level should not exceed the max mark. If you
wish, you can add bath salts to the water.
- Sit in a comfortable position and connect the appliance to the mains.
TURNING ON
The switch has several settings:
0 = off
1 = heat and vibration
2 = bubbles and vibration
3 = bubbles and heat
HEATING
A low-power heater has been installed in the hydromassage appliance underneath the area where the feet rest. When the heater is
operating, it prevents the hot water from cooling too quickly. The heater does not have enough power to heat cold water.
DURATION OF THE MASSAGE
10 minutes each day are enough to feel fresh and fit. If you wish, you can increase the duration or frequency of the massage. Never
stand up in the appliance.
You can increase the intensity of the massage by gently pressing your feet against the base.

CLEANING AND MAINTENANCE

- Always make sure that the appliance has been turned off and unplugged from the mains before emptying and cleaning. Never
empty the basin from the switch side. Always empty through the nozzle.
- After emptying, rinse with water and, if you wish, a little washing-up liquid.
- Never immerse the appliance in water.
- Coil the power cord around the cord storage located underneath the appliance.
REPAIRS
WARNING! Electrical appliances can only be repaired by authorised technicians as an incorrectly performed repair may cause
considerable damage.
Repairs should only be performed by a service centre authorised by the manufacturer.
7