Additional Information - Sunbeam HD3006 Manuel D'emploi

This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your safety.
This device is designed to make the appliance inoperable under some abnormal conditions
(such as accidental immersion in water).
After the appliance is plugged in, you must check your protective device as follows:
1. Press the "Reset" button on the ALCI device.
2. Press the "Test"' button. The "Reset" button will pop out. This verifies that the protective
device is working properly.
3. Press the "Reset" button once more to reactivate the safety device and use your appliance.
REPEAT THE AbOvE PROCEdURE bEFORE EACH USE
TO CONFIRM THAT THE PROTECTIvE dEvICE IS OPERATINg.
The Hair Dryer has three heat/air speed settings. To control the heat/air speed settings,
toggle the switch to the desired temperature and speed.
With the control setting switch in the "OFF" position, plug the Hair Dryer into a standard
125-volt AC outlet. Select the setting that is most appropriate to your needs and that will
deliver the best results.
When finished using the Hair Dryer, move the control switch to the "OFF" position and
unplug the cord from the outlet.
COOL SHOT BUTTON (Refer to Diagram)
When drying hair use a higher heat setting and switch to a lower heat setting when drying is
nearly complete. To finish, press the Cool Shot button
from the Dryer and blow cool air to lock in your hairstyle without causing over-drying or
damage to your hair.
Cool Shot button to deactivate heat flow from the dryer.
DISPOSABLE LINT FILTER
Your Hair Dryer comes with a disposable lint filter for labor-saving maintenance. It is
recommended to replace the filter every 6 months to prolong dryer life and enhance
cosmetics. To remove/replace: Open rear cover, remove and discard lint filter and replace
with a new filter.
Operating Instructions
To Use Your Hair dryer

Additional Information

. This will deactivate all heat flow
5