Use - Caso HD1000 Mode D'emploi

14.2 Use

1. Fill in water
1. Open the lid, fill the water tank with the desired amount of water.
2. Close the lid.
► The water level must be less than the Max level.
2. Obtain desired water
1. Make sure the plug is connected to the wall outlet.
2. Place your cup on the removable water tray, make
sure it aligns with the spout.
3. You can select the additional water tray attachment (2)
for various cup sizes.
4. First press about 3-5 seconds.
up.
5. Press to choose your desired temperature and
press to set the water volume.
6. Press to operate the appliance. After 5-10 s, the desired water will flow out
continuously from water spout. Press
obtained. The appliance will stop working at once.
If you want to obtain water again, repeat the steps above.
7.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
3. Water disposal from the water tray
1. When the water tray is full, grasp and stabilize the
appliance by one hand and use the other hand to lift up
the water tray slightly to remove it.
2. Empty the water tray and insert it into the original place.
Make sure it is properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
Caso Heißwasserbereiter HD1000
Please note
Please note
and light
again, when your desired amount of water is
28