Setup Location Requirements; Electrical Connection; Overheating Protection & Reset - Caso HD1000 Mode D'emploi

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 Place the device on a firm and even work surface.
 Do not use the device outdoors.
 Do not operate the product near hot gas or hot stove.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.
12.7 Overheating protection & reset
The appliance is equipped with an overheating protection facility. If the
temperature of the appliance exceeds the critical limit the appliance
shuts off further power supply for safety reasons.
Caso Heißwasserbereiter HD1000
By pressing the reset button (1) the appliance
can be reactivated.
Unplug the device before reset. When the device is only producing
cold water please press reset button.
Please use enclosed reset-key for the reset-button.
25