Lindy 32100 Manuel Utilisateur page 5

User Manual
5. Connect the USB DC cable. The LED on the top of the EDID/DDC Emulator Programmer will
immediately illuminate red and then blink once. Once the LED has blinked the EDID/DDC data has
been written to the Emulator Adapter.
6. Now connect the male interface of the EDID/DDC Emulator Adapter to your graphics card. The cloned
values (including monitor name) will then be available via your PCs operating system.
Troubleshooting
Windows shows a "Generic Non-PnP Monitor" is connected
Make sure that the EDID/DDC Emulator Adapter is directly connected to the graphics card or with the male
connector (with the arrow above it) pointing towards the graphics card if connected to a cable.
After cloning a display the preset values are still present/shown in the operating system
1. Repeat the cloning process, ensuring that the display is powered on and set to the VGA/DVI input that
you are cloning
2. Make sure that the LED on the EDID Emulator Programmer blinks blue to confirm cloning and then
red to confirm writing to the Emulator Adapter
Reboot the PC and reconnect the Emulator Adapter
English