Do not let detergent dry on the surface to prevent streaks.
13.5
START THE MACHINE
CAUTION
Do not operate without the water supply connected.
CAUTION
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
13.6
STOP THE MACHINE
1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
WARNING
If you do not use the machine:
•
Stop the machine.
•
Turn the water supply off.
•
Disconnect the power cord from the outlet.
•
Pull the spray gun trigger to release the remaining
pressure from the machine.
•
Engage the trigger safety lock-out on the spray gun.
NOTE
English
14
MAINTENANCE
Before maintenance, make sure that you
•
Stop the machine.
•
Wait until all the moving parts stop.
•
Disconnect the plug from the power source.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
15
NOZZLE MAINTENANCE
If there is too much pump pressure, the nozzle can become
clogged, you can feel a pulsing sensation while you pull the
gun trigger.
15.1
REMOVE THE NOZZLE
1. Pull back the quick-connect collar on the gun wand (3).
2. Remove the nozzle (4) from the gun wand (3).
15.2
CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool (14) to clean the
spray tip (4).
2. Flush and clean the unwanted materials out of the nozzle
(4) with the garden hose (15).
3. Install the clean nozzle (4) to the spray wand (3).
9
WARNING
WARNING
WARNING
WARNING
1
2
3
EN