Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
POSSIBLE
CAUSE
The water supply
is not sufficient.
The pump is draw-
ing in air.
The output pres-
sure varies high
and low.
The water intake
filter is clogged.
The supply volt-
age is low.
The gun, hose or
nozzle are calci-
fied.
English
SOLUTION
PROBLEM
Open water supply
The motor buzzes,
fully. Check gar-
but the machine
den hose for kinks,
does not start.
leaks, or blockage.
1. Make sure that
the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
Remove the filter
and Rinse in warm
water.
Make sure that on-
ly the pressure
washer is running
on the circuit.
Run distilled vine-
gar through deter-
gent tank.
There is no water.
18
Voltage
Frequency
Current
Max. Pounds Per Square Inch
Pressure
Rated Gallons Per Minute
Maximum Inlet Water Temper-
ature
Cleaning Units
11
POSSIBLE
CAUSE
The supply volt-
age is low.
The pump system
has residual pres-
sure.
Voltage loss due to
use of an improper
extension cord.
Pressure washer
not used for long
periods.
Residual friction
among compo-
nents. Unit might
emit a humming
noise.
The water supply
is off.
The garden hose is
kinked..
TECHNICAL DATA
120 V
60 Hz
13 A
1800 PSI
1.1 GPM
104 °F (40 °C)
1980 C.U.
EN
SOLUTION
Make sure that on-
ly the pressure
washer is running
on the circuit.
1. Turn "OFF"
the machine.
2. Pull the spray
gun trigger on
spray wand to
release pres-
sure.
3. Turn the ma-
chine "ON".
Disconnect the ex-
tension cord, and
connect the ma-
chine directly into
the outlet.
Call customer
service.
1. Disconnect the
water supply.
2. Power "ON"
the machine
for 2 to 3 sec-
onds.
3. Repeat the
above step a
couple of
times or until
the motor
starts.
Turn the water
supply on.
Remove kink in
garden hose.
Publicité
Chapitres
Table des Matières
Dépannage
