Return To The Initial Settings; Time Setting; Changing The Operating Mode Heating/Cooling; Setting The Temperatures - Elesta RTU200B Mode D'emploi

Return to the initial settings

You can carry out a general reset toreturn to the factory
settings:
- the installer settings (grayed out on the start up
menus),
- set-point temperatures,
- default program.
Turn the knob to Shutdown then
press the left-hand button for
10 seconds until init is displayed.
Press OK to confirm or C to
cancel.
Return to the shutdown mode
display.
10 sec.
- 28 -

Time Setting

Turn the knob to .
The days flash.
Press + or - to make your
choice, OK to confirm it and go
to the next setting.
Repeat the operations to set
the hours and minutes.
Turn the knob to exit the setting mode.
Changing the operating
mode Heating/cooling
To switch from HEAT mode to
(COOL) mode,
from the , or AUTO modes,
press the HEAT/COOL button for
3 seconds.
The change-over input of the heat
pump is not controlled by the
thermostat. You have to switch over manually.
Setting the temperatures (set-points)
Frost Protection setting (
Turn the knob to ( ).
Heat mode: setting from 5°C to 15°C (7°C by default)
Hours
Minutes
)
- 29 -
Day