Installation Procedure - EZA EZARPWM10 Manuel Utilisateur

3.2 Installation Procedure

Please make sure battery and solar panel are disconnected to controller, and do
not contact the positive and negative terminais of solar panel and battery at the
same time in case of electric shock.
A free space of 15cm on all sides must be provided for better heat dissipation.
Current density control system wiring cables within the 4A/ mm'.
Make sure installation site meets safety requirements first.
(1)
Make sure voltage of solar panel and battery are compatible with controller.
(2)
Connect battery to controller and check whether the LCD display is on, if not,
(3)
please solve the problem as mentioned in chapter 5.2.
Connect solar panel to controller accordingly. If there 's sunlight, controller starts
(4)
charging battery immediately and charging indicator arrow on LCD on.
Connect Joad to controller.
(5)