Beper RI051 Manuel D'instructions page 10

PTC Convector Heater Use instructions
Don't use the appliance with broken power cord after any damage. Once you suspect any problem,
deliver the appliance to the service center.
Operating instruction
Characters of the product
1.This product uses electrical heater and has high efficiency. There is not any open flames and
oxygen consumption.
2.The solid high-quality plastic housing has a long life span.
3.The product releases low noise. The ventilator is calm and pleasant, and produces a gentle wind
stream.
4.The product has an automatic swivel-distributor, so that the distribution of warm air takes place
evenly.
5.The two-stage Temperaturreglung is suitable for the different areas.
Electrical components Fig. 1
1 – Front protection grid
2 - Heating elements
3 - Control Panel
3A - On / off button
3B - Power LED
3C - FAN LED for ventilation
3D – 1000 watt power LED
3E – 2000 watt power LED
3F - TIMER button to set the sleep time
3G - Setting 1 hour timer LED
3H - 2-hour timer setting LED
3I - 4 hours timer setting LED
4 – Remote control
4A - On / off button
4B – TIMER button to set the sleep time
4C - 1000 watt power key
4D - 2000 watt power key
5 - Bracket for wall mounting
5A - 2 screws
5B - 2 fixing screws
Wall mounting Fig. 2
1.Assembly: The heater should be situated at least 1.8 meter above the floor.
2.The plug and power cord should be installed on height unavailable for children.
3. You need the following for installation: 2 soft inserts, 2 screws, 4 gaskets (all mentioned you will
find in gift box).
10