Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and then tighten
the 2 screws of fixations (Important,
watch that the screws have the same
strength of tightening).
2. Adjust the offset of the position.
3. During the mounting or the
dismounting of your cutting tools, block
the broach on flats planned for that
purpose, using the supplied spanner
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC-907
4. The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm
=> Shank diameter 9.1 mm minimum.
MARK : Never use the tool holder with
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
GSC-907 Mode
BT
d'emploi 1-.docx
Validation :14.10.15
Page : 2 de 4
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
Publicité
