General Information; Adjustment - Hayward KingShark2 DC Guide De L'utilisateur

you have purchased the finest piece of equipment in the pool cleaner industry. If you
treat it as such, your KINGSHARK2 DC automatic swimming pool vacuum cleaner will give
you long, satisfactory service. As a suggestion, the unit should be stored in the original
shipping container for safekeeping during the off season.
PleaSe retain tHe SHiPPinG CartOn WitH inner PaCKinG in tHe eVent tHe
Unit eVer neeDS SerViCinG.
tHere iS Only One aDJUStment tHat may Be neCeSSary FOr USe in yOUr
POOl. PleaSe taKe tHe FeW minUteS neCeSSary tO UnDerStanD tHiS
SimPle PrOCeDUre.
1. The height of the sensor bar RC3210 (Fig. 1, Key 2) is pre-set at the factory for
average pools. It may be necessary to readjust the height of the sensor bar for
the machine to operate satisfactorily in your pool.
2. In "Free Form" or "Bowl Shaped" pools, the sensor bar may have to be raised to
a higher setting to allow the machine to climb out of the deep end and clean up
the radius or slope as far as possible without the machine turning over.
3. Adjustment of the sensor bar RC3210 (Fig. 1, Key 2) is made by loosening adjust-
ing arm bolt RCx2121B (Fig. 1, Key 8) located just ahead of the intake. With the
machine sitting on a level surface, loosen both adjusting arm bolts, and move
sensor bar to desired position. Make certain the sensor bar is parallel to the level
surface and retighten the adjusting arm.
4. It may be necessary to reset the sensor bar several times to find the best position
for operation in your pool. Sensor bar should glide freely. This can be checked by
pushing back sensor bar which will activate the reversing arms.
1. Plug the KINGSHARK2 DC into the control box receptacle.
Plug the control box RCx5992DC into an outlet Only with
2.
protection device to protect people from electric shock caused by a
possible break in the electrical insulation.
CaUtiOn: aVOiD OVerlOaDinG tHe CirCUit aS lOW Or HiGH VOltaGe
Can DamaGe yOUr mOtOr
3. Check the ground fault circuit interrupter by first depressing the test button and
then pushing the reset button located on the

General inFOrmatiOn

aDJUStment

OPeratinG inStrUCtiOnS
6
a 30 mA differential
30 mA differential protection
.