THOMSON MIC192U Mode D'emploi page 18

INSTALLATION
INSTALLATION (See pictures below)
The device can be installed:
On a stand (6):
• Put the hooks from the base in the central cavity at the
back of the device. Check that the base does not come
off. To remove the base, pull it downwards.
6
On the wall:
• Use a spirit level to mark the holes to be drilled.
• Drill holes at the marked points then insert the wall
plugs.
• Attach the 2 fixing wedges to the wall using the 2
screws (included).
• Screw in the 2 screws (included) to the wall.
Then attach the sound bar and make sure it is stable.
Fixing wedges
Screw
EN 16
BLUETOOTH
MIC192U
MAINS POWER SUPPLY
Caution:
• Risk of damaging the product! Make sure that the input
• Connect the mains adapter plug to the socket (5).
• Connect the adapter to a plug socket.
• Only use the adapter provided. To use another adapter,
TURN ON / STANDBY
Press q to switch on the device or put it in standby mode.
Note:
• When the device is turned on, if it is not used for 20
SETTING THE CLOCK
In stand-by mode:
• Press CLOCK SET.
• Press 7 or 8 to 12 or 24 hours mode.
• Press SELECT to confirm: the hour display flashes.
•
•
SET THE ALARM
• Press and hold during 2 seconds ALARM1 / ALARM2:
• Adjust the hour using the 7 or 8 keys, then press
• Adjust the minutes using the 7 or 8 keys, then press
• Press 7 or 8 to select BUZZER / RADIO / CD /
• Press 7 or 8 to adjust the volume.
ACTIVATE / DEACTIVATE AND STOP THE ALARM.
To enable:
• Press ALARM1 / ALARM2: symbols
To disable:
Wall plugs
• Press ALARM1 / ALARM2 to disable: until the symbols
plastic
To stop:
• When the alarm sounds, press q to stop it.
To repeat:
• Press SNOOZE on the remote control or any key on
4
MICRO SYSTEM
®
voltage corresponds to the voltage indicated on the
device.
check that it has identical characteristics and is
compliant with current standards.
minutes, it automatically switches onto standby mode.
Adjust the hour using the 7 or 8 keys.
Press SELECT to confirm: the
Adjust the minutes using the
Press SELECT to confirm.
symbols / and the hour display flashes on the
screen.
SELECT to confirm: the minutes
SELECT to confirm.
USB as a source of alarm, then press SELECT to
confirm. Note: If the USB source is selected, but no
USB device is connected, the unit will switch BUZZER
automatically.
(The default alarm volume is 15).
the screen.
/ disappear.
the device to temporarily stop the alarm, that alarm
will sound again after 9 minutes for 60 minutes. The
symbols / flashes and the SNOOZE symbol
appears on the screen.
USE
minutes display flashes.
7 or 8 keys.
display flashes.
/ appear on