Programme Selection Knob; Indicator Lights - Indesit IDCA H G55 B Mode D'emploi

ON/OFF/Reset button
Pressing the button normally will cause the machine to switch on or off. If the button is pressed for 3 seconds while the dryer is in
EN
function, the machine will switch off and the running cycle will reset.

Programme selection knob

Allows for setting the programme: turn until the indicator points towards desired programme (see Starting and selecting a programme).
Options buttons
Allow for selecting the options available for the selected programme. The relative indicator lights turn on when the option has been
selected (see Programmes and options).
START/PAUSE button and indicator light
When the green light flashes slowly, press the button to start the programme. When the cycle is under way, the indicator light remains
on. To put the programme into pause mode, press the button again; the indicator light will turn orange and start flashing again.
To resume the programme from the point it was interrupted, press the button again (see Start and programme selection).

Indicator lights

"Maintenance" indicator lights
The indicator lights provide important information. They indicate the following:
The "Empty water container" indicator light signals that the water container must be emptied.
If the water container fills during the course of the programme, the LED lights up. The dryer automatically starts a COOL TUMBLE cycle
and the START/PAUSE LED flashes orange. Press the START/PAUSE button to resume the cycle from the point it was interrupted.
In order to avoid this procedure, always empty the water container after using the tumble dryer (see Care and maintenance).
Before each programme, the "Clean filter" indicator light signals that it is essential to clean the filter each time before using the
tumble dryer (see Care and maintenance).
The "Clean condenser unit" indicator light signals that it is essential to clean the condenser regularly (see Care and maintenance).
"Drying phases" indicator lights
The indicator light signals that the drying phase is running.
The indicator light signals that the cooling phase is running.
The END indicator light signals that the programme has ended.
"Delay timer" indicator light
If the "Delay timer" option has been activated (see "Programmes and options"), after the programme has started, the indicator light
corresponding to the chosen delay time will start flashing:
As time passes, the remaining delay will be displayed and the corresponding indicator light will flash:
Once the set delay time ends, the flashing LED will turn off and the set programme will start.
22