Keurig B150 Manuel Du Propriétaire page 9

Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa from a
packet, or for use in cooking, etc. Simply follow the instructions on page 7,
"Ready To Brew Your First Cup" without adding a K-Cup.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water
brew cycle without a K-Cup.
Purging the Brewer
If your Brewer has not been used for more than one week, you should
purge the water from the internal water tank.
If there is water in the Water Reservoir, remove the Lid, then lift the
1.
Water Reservoir straight up and away from Brewer. Discard water,
rinse and refill with water. Place the Water Reservoir back on the
Brewer and replace the Lid. (If there is no water in the Water Reservoir,
simply refill.)
Be sure the Brewer is turned 'ON'. Raise and lower the Handle on the
2.
Brewer without inserting a K-Cup.
3. The LCD Display will be in its idle state (fig.4).
Place a large mug on the drip tray and
4.
10
fig.
select Large Mug (10 oz. serving) brew size
from the Select Brew Size Menu (fig.10).
5. Discard water.
Select
Brew Size
Repeat steps 2 - 5 two more times to
6.
4 OZ.
completely purge water from the Internal
Hot Water Tank.
6 OZ. 8 OZ.
10 OZ. 12 OZ.
9