Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Note: - From now on, every week, your TV will automatically
switch to the selected channel, on the selected day,
at the selected time, until the On timer function is
switched off again.
- Only one On timer can be set.
Installation menu
Channel menu
On timer (applicable for off-air channels only)
From standby, this automatically switches the TV to the specified channel
number, at a specified time.
&
Select On timer.
é
Press the cursor right to enter the On timer menu.
"
Select Timer and press the cursor right.
'
Select On.
(
Select Channel and then the TV channel you want your TV to switch to
on a selected time and day.
§
Select Day and then a day of the week or select Daily.
è
Select Time and enter the time with the digit keys or with the cursor up/
down.
!
Press the OK key to activate.
ç
Press the cursor left to return to the Features menu or press the MENU
key to switch off the menu.
Select the menu language
&
Press the
button on the remote control.
MENU
é
Use the cursor down to select
"
Use the cursor right to enter the Installation menu.
'
Select
Language
and enter the list of available languages with the cursor
right.
(
Select your language with the cursor up/down and press the
confirm you selection.
§
Proceed with the Installation menu.
Store TV channels
&
Select
Channels
in the Installation menu.
é
Use the cursor right to enter the Channels menu.
"
Select
in the Channels menu.
Autoprogram
'
Use the cursor right to enter the Autoprogram menu.
(
Press the
button.
OK
§
Select
Cable
or
Antenna
in the Installation mode.
When
is selected, the TV will detect antenna signals and will
Antenna
search for antenna TV (NTSC and ATSC) channels available in your local
area.
When
Cable
is selected, the TV will detect cable company supplied signals
and will search for cable TV (NTSC, ATSC, QAM modulated) channels
available in your area.
Make sure that registration with your cable TV provider and connection of
equipment are completed.
è
Press the green button "
Next"
Note: All channels must be unlocked in order to autoprogram. If requested, enter
your PIN code to unlock all channels.
!
Press the green button "
Start"
The menu screen disappears and the progress of autoprogramming is
displayed. The progress bar indicates the number of analog and digital TV
channels found.
When Autoprogramming is complete, a message appears confirming
the completion. Press the red button "Finish" and the TV returns to the
Installation menu.
18
Installation
in the TV menu.
OK
on the remote control.
to start autoprogramming.
button to
Publicité
Chapitres
Table des Matières
Dépannage
