EIBENSTOCK EMF 125.2 Notice Originale page 23

Fig 6
Press the spindle lock button to lock the work spindle (see arrow – Fig.4).
Screw on the clamping screw and tighten it with the face spanner (see
Fig.5).
Instructions for assembly:
Regardless of the requested grove width, all spacer discs
•
provided must always be mounted.
Otherwise, the diamond cutting disc can become loose during
operation and lead to injuries.
At least one spacer disc must be mounted between two diamond
•
cutting discs.
When mounting the diamond cutting discs, ensure that the
•
direction of rotation arrows on the diamond cutting disc match
with the rotation direction of the machine (see direction of
rotation arrow on the protective hood).
Always replace the diamond cutting discs in pairs.
•
Use only original accessory!
•
The wall chaser is in power and speed optimal adjusted to the
•
EIBENSTOCK-diamond cutting discs.
Thus you reach the best work result in consideration of the
•
material to be worked on (see accessories).
In order to check whether the spindle stop is released before you
switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
First the wheel flange has to be mounted on
the work spindle (see arrow).
The wheel flange with its driving must have a
correct seat on the work spindle.
Then mount one of the two diamond cutting
discs.
After that put the spacer discs and the second
diamond cutting disc according to the
required groove width on the work spindle.
23