BoomToneDJ KUB 400 RGB Mode D'emploi page 20

Zoom of the pattern
CH8
Color selection
CH9
1. If you are using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug
it in the DMX-output of the last unit.
3. Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit
to the input of the next unit. The cable can not be branched or split to a 'Y' cable.
DMX512 is a very high-speed signal. Inadequate or damaged cables, solder joints or
corroded connectors can easily distort the signal and shut the system down.
4. Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
6. Troubleshooting
There is no replacement part inside. Please contact your dealer for any
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:

The fixture does not work, no light
o Check the connection of power and main fuse.
o Measure the mains voltage on the main connector.

Not responding to DMX controller
o DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
o If the DMX LED is on and no response to the channel, check the address
0-63
64-255
0-255
NEVER OPEN THE FIXTURE
problem.
fast)
Invalid
Pattern zooming(from slow to fast)
Pattern color selection
19