Duraflame DFH-DH-14-T Manuel D'utilisation Du Propriétaire page 6

Céramique 1 500w
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION INSTRUCTIONS
1. Place the product upright on a flat, level, stable, heat-resistant surface, and then plug
the Power Cord into a standard 120-volt electrical outlet.
2. Main Control Knob: Use this knob to set the heat setting (Figure B):
" "- Fan Only (no heat)
"I" – Low Heat Setting (900 Watts)
"II" – High Heat Setting (1500 Watts)
3. Turn the Thermostat Control Knob clockwise to its maximum range (Figure B). The
Power Indicator will illuminate, indicating the Heater is on.
4. Allow the product to operate until the ambient room temperature reaches the desired
comfort level.
5. Slowly turn the Thermostat Control Knob counter-clockwise until the product turns
off. The product will cycle on and off to maintain the setting.
6. To adjust the thermostat, turn the Thermostat Control Knob towards maximum to
increase the set ambient temperature and towards minimum to decrease it.
7. Oscillation Switch: Use this switch to turn the oscillation function on and off (Figure B).
WARNING: Insure that no objects will be near the heater during the full range of
oscillation when using this function.
8. Turn off the product by rotating the Main Control Knob to the "OFF" position, and
then unplug the product from the electrical outlet.
WARNING: Always unplug the product when it will be left unattended or not in use.
Safety Protection Systems
This product has protection safeguards that shut off the product when parts become
excessively hot or if it tips over. If the product shuts off, immediately turn the Control to
the "OFF" position and unplug it from the electric outlet.
If overheated:
a. Remove any objects near the product that may cause overheating. Use the product
in a well-ventilated area. Keep at least 3 feet (0.9 meters) of space on all sides
of the product to allow adequate air circulation.
b. Allow the product to cool down for at least 10 minutes before plugging it back into
an electric outlet for re-use.
If tipped over:
Place the product on a flat, level, stable surface in order to prevent the product from
tipping over again.
TIP: Always install and maintain at least one smoke detector in good operating
condition on each floor of your home. Periodically check and/or replace the battery in
your smoke detector with a new battery.
E-5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dfh-dh-14-to

Table des Matières