Box Contents; Use Of The Product; Connecting The Power Cable - Greencut SOLDADOR MMA180 Manuel D'utilisation

38

BOX CONTENTS

This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Ground cable
-
1x Electrode holder clamp cable
-
1x Welding mask
-
1x Pickaxe / brush
-
1x User manual
• Remove the product and accessories from the box. Make sure all items are present.
• Inspect the product to ensure that it has not been broken or damaged in transit.
• Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, please contact the Official Technical Service. Do not
use this product without replacing the part. Using this product with damaged or missing parts can
cause serious injury to the operator.

USE OF THE PRODUCT

INSTALLATION
NOTE: Check that the power supply voltage corresponds to the voltage indicated on the technical
data label of the welder.
-
The input power must be AC 230 V (15%). Blue cable: negative connection. Red cable: positive
connection. Yellow/Green cable: ground connection. It is dangerous if the connections are not
correct.
-
Please check the power input cable.
-
If it is not in good condition, it can cause a fire.

CONNECTING THE POWER CABLE

-
Connect to a grounded outlet.
-
Check that it is not rusted.
-
Check that the voltage is within the safety parameters (230 V +/- 15%).
CONNECTING THE OUTPUT CABLES
-
Use the EU connector on the front panel of the machine.
Make sure it is properly connected; otherwise you can burn the machine in the event of overload or power surge:
• The ground cable to the front fitting of the welder with negative pole (-).
• The electrode clamp cable to the positive pole (+).
INSPECTION
-
Connect to a ground connection correctly.
-
Check that the connection cable is in good condition.
-
Make sure that there is no wood or flammable products nearby.