Lea LE20055 D Mode D'emploi page 16

8. OPERATION
8.1 Starting
To switch on the trimmer first press the On/Off trigger (3). To switch off simply release the
On/Off switch trigger(3)
When the trimmer line is too short to good cutting, please pump the wire head on the firm
surface to make the wire with appropriate length.
Do not overload the trimmer, cut in small sections which will greatly improve efficiency by
keeping the trimmer running at high speed.
9. TROUBLE SHOOTING
PROBLEM
Line will not advance
Cutting head is hard to
turn
Grass continually wraps
around the shaft and
trimmer head assembly
Line trimmer stops and
will not start again
10. CLEANING AND MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off and unplug the tool.
Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
Regularly clean the cutting line and spool using a soft brush or dry cloth.
Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.
11. WARRANTY
POSSIBLE CAUSE
•
Line is welded to itself
•
Not enough line on the
spool
•
Line has worn too short
•
Line is tangled on the
spool
Grass wrapped or built up
around head
Cutting tall grass at
ground level
Unit failed
Plug is damaged
15
SOLUTION
•
Lubricate with a silicone spray
•
Replace the spool
•
Remove the spool and feed line out
•
Remove line from spool and rewind
Clean the effected parts of the machine
Cut tall grass from the top down
Contact dealer to check damage
Check the plug