Kenwood KAC-8401 Mode D'emploi page 6

Connection
■ Terminal names
8 Fuse (40 A)
NOTE
If you can't find the specified capacity fuse at
your store etc., consult your Kenwood dealer.
9 Battery terminal
0 Ground terminal
! Power control terminal
Controls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect
it with all the systems.
@ Speaker output terminals
• Stereo Connections:
When you wish to use the unit as a stereo
amplifier, stereo connections are used.
The speakers to be connected should
have an impedance of 2Ω or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 2Ω or greater for each
channel.
• Bridged Connections:
When you wish to use the unit as a high-
output monaural amplifier, bridged
connections are used. (Make connections
to the LEFT channel 9 and the RIGHT
channel · SPEAKER OUTPUT terminals.)
The speakers to be connected should
have an impedance of 4Ω or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 4Ω or greater.
2CAUTION
The rated input of the speakers should be
no less than the maximum output of the
6
English
8 9 0 !
#
amplifier. Otherwise malfunction may
result.
# RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
$ LINE IN terminal
% LINE OUT terminal
These jacks output respectively the signals
input to amplifiers A and B. They always
output the stereo signals regardless of the
position of the OPERATION switch.
^ Speaker level input terminals
• The genuine-accessory car stereo shall
• Do not connect the speaker output leads
• Do not connect cables and leads to both
• Connect the power control lead to a
@
$ % ^
NOTE
have a maximum power output of no
more than 40 W.
from a power amplifier (Optional) to the
speaker level input terminals of this unit,
for this may cause malfunction or
damage.
RCA cable input jacks and the speaker
level input terminals simultaneously, for
this may cause malfunction or damage.
power supply which can be turned
ON/OFF by the ignition key switch (ACC
line). With this connection, shock noise
may be generated when the power of the
genuine-accessory car stereo is switched
ON/OFF.