Urmet 1093 Guide Rapide page 13

5. Press the "Search" (Ricerca) button to open the following page showing all the
available WiFi networks and the signal power detected for each one:
6. Select the SSID of the WiFi network you want to connect the camera to, enter the
network key and save the configuration by pressing the "Save" (Salva) button.
It is advisable to check that the WiFi signal received by the camera is higher than or
equal to 60.
7. Disconnect the network cable from the camera to switch it to WiFi mode. Press the
"Refresh List" (Aggiorna) button of "EasyTool" to check that the camera appears
again when it is connected to the WiFi network.
8. It is advisable to assign a static IP address to the camera: see section 3.3 of this
guide to perform this operation.
9. After having installed the camera in the desired point, if it provided with autofocus
motorised lens, adjust the zoom level on the LIVE web page of the page.
DS1093-558
13