ETNA VW339M Mode D'emploi page 69

OPERATION
Changing a wash cycle
1. Open the door.
▷ The last selected program appears on the display.
2. Press the program key to select a new programme.
▷ If the door is opened during operation, the time remaining of the
selected program will show on the program display.
3. After closing the door, the newly selected Program will resume the
course of the old Program.
After the door is closed, the water discharge process will start and
continue for 30 seconds. When a Program is cancelled, a buzzer will
sound 5 times.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
Cancelling a wash cycle
1. Open the door.
▷ The last selected program appears on the display.
2. Press and hold the program key for 3 seconds. The program display
will count from ''3 to 1'' and then show ''0:01" to indicate that
cancelling is ready.
▷ After the door is closed, the water discharge process will start
and continue for 30 seconds. When a program is cancelled, a
buzzer will sound 5 times.
Warning!
Opening the door fully during the wash cycle is dangerous. You may be
splashed with hot water from the machine.
Switching the Machine Off
When the selected wash Program is complete, a buzzer will sound
5 times. You can then switch off the dishwasher using the On/Off key.
EN 9