LOGICOM L-623 Manuel D'utilisation page 30

Tip: If the memory card does not work, check that it is inserted correctly and
also check the metal contact points. You can also try to format the memory
card. You shouldn't have to close the metal clip with a lot of strength.
Installing the battery

Remove the back cover from the phone.

Place the end of the battery that has the metal contacts against the battery
connector.

Gently push the battery down and press on the other end of it to snap it in.
CAUTION: Risk of explosion if battery is replaced by an incorrect type.
Model: Z23221 Li-ion battery 3,7V DC / 1000mAh.
To replace the battery, please enquire with the after-sales service of your dealer.
Dispose of used batteries according to the instructions.
Charging the battery:
 To charge the battery, connect the USB cable (supplied) to the USB port of
your Feature phone and the other end to the mains adaptor (supplied). Then
connect the mains adaptor to a power outlet.
 The battery charge icon illuminates during charging and indicates the charge
status.
 When the battery is fully charged, you can disconnect the USB cable from the
device then from the power outlet.
IMPORTANT:
 The Feature phone is only recharged via its USB port.
 Ensure your Feature phone is fully discharged before charging it for the first
time.
 The battery must be charged for at least 5 to 8 hours when first charged.
 After a long period without use, It should be necessary to do many cycles of
charging / discharging to obtain maximum power capacity
Installation and charge of battery
29