Cleaning And Maintenance - Toolland TM81008 Mode D'emploi

6.5 Advice on Using the Rotary Hammer
 Always use the auxiliary handle provided with the device. A well-controlled device greatly increases the
working precision.
 When drilling ferrous metals:
pre-drill a small hole when a larger hole is required
o
occasionally lubricate the drill bit with oil
o
 When drilling at or near the cross cut end or an edge of wood:
pre-drill a small hole in order to avoid cracking of the wood
o
 In all cases, do not apply big pressure on the device. The hammer mechanism is activated by applying
a slight pressure on the device when the drill bit is in contact with workpiece.
For the best results, only apply a slight pressure needed to keep the automatic clutch engaged.
7.

Cleaning and Maintenance

 Keep the ventilation openings clear, clean and dust-free at all times.
 If the device is running erratically or something unusual occurs during use, immediately switch off the
device and unplug from the mains. Inspect the device before using it again. Repair must only be carried out
by a qualified technician.
 If the supply cord is damaged, it must be replaced by a qualified technician.
 Wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong
detergents.
 Clean the device and accessories before storing.
Storing
 Store the device, its accessories and this user manual in the original packaging.
 Always store in a cool and dry place.
V. 01 – 07/07/2016
TM81008
Angle-adjusting mode:
This mode is only for angle adjustment. You still
need to switch to the hammer mode for the hammer
mode.
Drilling mode:
To drill in wood, synthetic materials and metal.
No function:
The motor turns without load and the shaft will not
turn. Do not use this function as it may damage the
device's motor.
6 ©Velleman nv