U.S.Robotics Wireless MAXg USB Adapter Guide D'installation page 6

E. Turn on your cable or DSL modem.
Note to UK Users: Attach the correct power plug to the power adapter.
Note: You have finished connecting the Wireless MAXg Router and will now need to install
the Wireless MAXg USB Adapter.
Step Two: Install the Wireless
A. Insert the USB Adapter Installation CD-ROM into the CD-ROM drive of the computer you are
installing the USB Adapter in. The Installation CD Graphical User Interface (GUI) will appear
on your screen. If prompted, select your preferred language.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, type
D:\setup (if your CD-ROM drive uses a different letter, type that letter in place of "D"), and
click OK.
B. Click Installation.
C. Follow the on-screen instructions.
D. When prompted, locate an available USB port and
fully insert the Wireless MAXg USB Adapter.
Windows XP users should follow any on-screen
instructions.
E. When prompted, click Restart to restart your computer.
Note: You may see a screen which says "Digital Signature Not Found" or "Windows Logo
testing". Click Yes or Continue Anyway. U.S. Robotics has thoroughly tested this driver in
conjunction with the supported hardware and has verified compatibility with Windows XP
and 2000. Because U.S. Robotics wants its customers to take full advantage of the
network card's functionality, it has made the drivers available.
Step Three: Set up a Wireless Network
A. When your computer restarts and you are prompted, select Configure a new U.S. Robotics
2
MAX
g USB Adapter