Package Contents - D-Link DSN Série Guide D'installation

Quick Installation Guide
4x1GbE iSCSI SAN ARRAy wIth 5 SAtA bAyS

Package Contents

If any of the items are missing, please contact your reseller.
DSN-1100 CD ROM
Connect to DSN Series SAN Array
A. to install the hard drives:
Place the hard drives into the drive trays and secure with mounting screws on the drive
trays. then gently insert the assembled drive trays into the enclosure until the latch clicks.
b. Attach an Ethernet cable to 1GbE data port 0 on the rear panel and to your server or SAN
switch. Facing the rear of the SAN array, the data ports are on the left side. to connect
additional data ports to your SAN array, repeat this step using another Ethernet cable and
the next data port.
C. the management port can be connected to the server either by directly attaching a crossover
cable, or via a switched infrastructure using a standard Ethernet cable. Facing the rear of
the SAN array, the management port is on the right side of the I/O panel. by default, this port
is set to the IP address of 192.168.1.1. this can be changed using the web based wizard.
D. the diagnostic port can optionally be used for diagnostics. It connects to an RS-232C port
on your host computer configured for a baud rate of 9600bps at eight data bits, no parity bit,
one stop bit and no hardware handshake, using a standard DB9 cable.
DSN-1100
Console cable
Example of Connecting to DSN Series SAN Array Rear Panel
Power cable keys
2
Screws