Installation - EuroLite LED Neon Flex Mode D'emploi

INSTALLATION

The LED Neon Flex s ystem is a versatile and user friendly linear lighting device; it can be cut and bent and
formed in the field and easily installed on flat surfaces of varied materials, such as wood, plastic, steel, or on
walls to form all kinds of pattern according to your design.
Procedure:
Step 1: Unpack the lighting chain.
Step 2: In order to design the desired pattterns, draw the form onto the surfach and attach the mounting-
channels.
Step 3: Insert the light tubes into the m ounting channels with the illum inating side upwards.
Step 4: Connect the light tubes. Make sure the poles of the connceting pins are correct (see system
overview). The tube is waterproof (IP 44). Nevertheless, you have to insulate the connectors and
the power connector with the supplied heat shrink tubes for outdoor use.
Cutting marks
The lighting tube may only be cut on the indicated mark. (see „Technical Specifications").
Mounting channel
100 cm aluminum channel
WARNING!
Only cut the tube where marked.
5 cm aluminium channel
19/43 50502955_V_1_0.DOC