Technical Specifications - Velleman VTSS5U Mode D'emploi


Unscrew the coupling nut on the soldering iron and remove the soldering tip. Clean off the rust which
may have formed in the cylinder. Don't ever try to remove the soldering tip during use (burn
hazard). If the soldering tip should loosen during use, turn off the soldering station and let the
soldering iron cool down until it has reached room temperature. Then tighten the coupling nut.

After removing the tip, you should blow out any oxide dust that may have formed in the tip
receptacle. Be careful not to get dust in your eyes. Replace the tip and tighten the screw. Pliers can
be used to avoid contact with hot surfaces but should be used with caution because over-
tightening may cause damage to the element or fuse the tip to the element.

The outer cover of the iron and station may be cleaned with a damp cloth using small amounts of
liquid detergent. Never submerse the unit in liquid or allow any liquid to enter the case of the station.
Never use any solvent to clean the case.

If the iron or station should become faulty or, for some reason does not operate normally, the
system should be returned to the service department of your authorized dealer or service agent.
8.

Technical Specifications

heater power for soldering iron .........................................................................................50 W
temperature........................................................................................................... 374-896 °F
voltage supply ............................................................................................................ 115 VAC
weight ........................................................................................................................2.65 lbs
dimensions ....................................................................................... 7 1/4" x 3 31/32" x 3 1/2"
input power .......................................................................................................... 50 VA max.
spare bits (sold seperately) ............................................... BITS5, BITS5C/1, BITS5C/2, BITS5C/3
Use this device with original accessories only. Velleman Inc. cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.vellemanusa.com. The information in this manual is subject to change without prior
notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Inc. All worldwide rights reserved. No part of this manual
may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior written consent
of the copyright holder.
1. Introduction
Informations environnementales importantes concernant ce produit
Ce symbole sur l'appareil ou l'emballage indique que l'élimination d'un appareil en fin de vie
peut polluer l'environnement. Ne pas jeter un appareil électrique ou électronique (et des
piles éventuelles) parmi les déchets municipaux non sujets au tri sélectif ; une déchèterie
traitera l'appareil en question. Renvoyer cet appareil à votre fournisseur ou à un service de
recyclage local. Il convient de respecter la réglementation locale relative à la protection de
l'environnement.
En cas de questions, contacter les autorités locales pour élimination.
Nous vous remercions de votre achat ! Lire la présente notice attentivement avant la mise en service de
l'appareil. Si l'appareil a été endommagé pendant le transport, ne pas l'installer et consulter votre
revendeur.

La VTSS5U est pourvue d'une échelle analogue électronique qui est pilotée par la température (de
374 à 896°F).

Le fer à souder est mis à la terre.

L'appareil est allumé/éteint avec le réglage rotatif de température. Une LED brille quand l'appareil est
allumé.
V. 04 – 16/04/2018
VTSS5U
MODE D'EMPLOI
6 ©Velleman nv