Toshiba Carrier MMK-AP0157HPUL Manuel D'installation page 15

Changing MOUNT-COUNT
● Step to remove the MOUNT-CONDUIT
1) The MOUNT-CONDUIT can be removed by removing the screw securing
the MOUNT-CONDUIT and them pulling out the MOUNT-CONDUIT.
2) Remove the MOUNT-CONDUIT by direction backside of unit.
3) Remove the EDGE-SADDLE
take off from MOUNT-CONDUIT.
● Step to install the MOUNT-CONDUIT (Option connect power supply 2 Hole)
1) Install the EDGE-SADDLE to MOUNT-CONDUIT
2) Install the MOUNT-CONDUIT to unit
Make sure to fix pin
on position lock.
– 14 –
Remove the screw 1 part.
Make sure screw 1 part fix on position.
Installation Manual
3) Insert the screw.
14-EN
EN