Changing Air Sources - Jolife LUCAS Instructions D'utilisation

1(
50
I U
N S T R U C T I O N S F O R S E
3.7.5 M
In situations where conditions do not allow the
chest to remain horizontal:
1. Turn the
compressions (Figure
2. As soon as the patient is in horizontal position,
check the position of the suction cup and
adjust if necessary (see Section 3.4).
3. Turn the
3.7.6 A
Make sure that the patient is fixed when using
LUCAS Chest Compression System during
ambulance transport. The ambulance cot should
have four-point restraints for the patient's upper
body in addition to the two lower-body restraints.
3.8 C
HANGING AIR SOURCES
WARNING – INTERRUPTED COMPRESSIONS
Excessive changeover time if regulators have to be
Always use reserve cylinders with pre-fitted
To change air source:
1. Set the
2. Close the valve on the used air cylinder.
3. Disconnect the air hose from the air source.
4. Open the valve on the new air source.
5. Attach the air hose to the new air source.
6. Adjust the height of the suction cup on the
patient's chest, as described previously on
page 40.
7. Turn the
8. Turn the
continue compressions.
G
E B R U I K S A A N W I J Z I N G
O V I N G P A T I E N T O N T I L T E D S T R E T C H E R
knob to
ON/OFF Lock
1(
).
knob to
ON/OFF Active
M B U L A N C E T R A N S P O R T
mounted.
regulators.
knob to
ON/OFF Adjust
knob to
ON/OFF Lock
knob to
ON/OFF Active
100359-50 B, ©J
I
N S T R U C T I O N S D
to pause
.
.
.
to
AB 2006
O L I F E
LUCAS
T M
'
U T I L I S A T I O N