POWERTEX PCB-S1 Manuel D'utilisation page 5

Checklist for periodic checks
Daily Yearly Inspection items
Labels
X X Rating plate
Function
X X Raising and lowering function
- X Raising and lowering function
Hooks
X X Hook opening
-
X X Deformation
X Hook bearing
X X Wear, cracks, deformation and corrosion
-
X Hook bearing
Load chain
X X Pitch
-
X X Wear
-
X X Deformation
X X Cracks etc.
X X Rust
Housing
X X Frame
X X Gearbox
- X Gears
- X Load chain sprocket
- X Hand chain sprocket
- X Bearings
Screws
X Screws, nuts, rivets, cotters etc.
Brake
- X Brake disk
- X Brake screw
- X Pawl and ratchet
(normally yearly – more frequently if necessary)
Inspection method Note
Visual If the plate is hard to read - replace it
Test without load A low snapping noise should be audible
Test with rated weight Load chain sprocket and chain work well together.
for min 300 mm Brake works.
Hand pulling on the hand chain feels even and
not too heavy
Visual Looks normal
Measurements See Fig. 4 and Table 1
Visual No visibel deformation
Visual No abnormal play
Visual No visible damage
Measurements See Fig. 4 and Table 1
Visual No abnormal play
Visual Looks normal. Measure in case of doubt
See Fig. 5 and Table 2
Measurement
Visual Looks problem-free.
Measurement Measure in case of doubt
See Fig. 5 and Table 2
Visual No deformation. Measure in case of doubt
Visual No cracks
Visual No rust
Visual No deformation and no rust
Visual No deformation
Visual after dismantling No serious wear or fractures
Visual after dismantling No serious wear or cracks.
No fractures or deformation
Visual No serious wear or cracks.
No fractures or deformation
Visual, testing No damage, smooth running
Visual Must not be missing. Tighten loose items.
Replace as necessary
Visual Replace if worn
Visual No serious wear
Visual Replace worn parts.
Carefully lubricate with grease
5